iBoard
®
Customer Support: [email protected]
Rev. 20220601
4
(Fig 4) Driver Side Rear Mounting Location
Rear
STEP 4
Once all (3) Mounting Brackets have been installed, select a
Running Board. Slip (3)
M6X1-20mm Square Head Bolts into
each bottom channel
(Fig 5)
. Carefully position the Running
Board onto the (3) Mounting Brackets. Attach the Running
Board to each Mounting Brackets with (2) M6X1-20mm Square
Head Bolts, (2) M6 Large Flat Washers and (2)
M6 X1 Nylon
Lock Nuts
(Fig 6)
. Do not fully tighten at this time.
IMPORTANT
: Do not slide the Running Board on the Brackets
or the bottom surface of the board will be damaged.
M6X1-20mm Square Head Bolts
(Fig 5) Slip M6X1-20mm Square Head Bolts Into The
Bottom Channels
(Fig 6) Running Board Installed Onto Mounting Bracket
(2) M6X1-20mm Square Head Bolts
(2) M6 Large Flat Washers
(2) M6X1 Nylon Lock Nuts
STEP 5
Level and adjust the Running Board and fully tighten all hard-
ware.
Important: Please follow the recommended Tightening Tor-
ques shown in the table on page 1.
Don’t over tighten, or
the nuts/bolts will be damaged.
STEP 6
Repeat
Steps 1-5
for the other side Running Board installation.
The installation is completed .
Attention
Do periodic inspections to the installation to make sure
that all hardware is secure and tight.
In order to protect your bars/boards, please use mild
soap/non-abrasive products for cleaning only.
