(6",5”,4))RUNNING BOARD
FOR 1997-2003 Ford F-150/F-250LD Regular Cab (Incl. 04 Heritage)
Rev:20181101
Page 2 of 4
PARTS LIST:
Item QTY
Description
Item QTY
Description
#1
2 Running Board(use for left or right)
#12
8 8mm Hex Nuts
#2
1 Driver/Left Front Upper Mounting Bracket(DFM)
#13
8 10mm ID x 30mm OD x 2.5mm Flat Washers
#3
1 Driver/Left Rear Upper Mounting Bracket(DRM)
#14
8 10mm Lock Washers
#4
1 Passenger Front Upper Mounting Bracket(PFM)
#15
8 10mm Hex Nuts
#5
1 Passenger Rear Upper Mounting Bracket(PRM)
#16
4 12mm x 35mm Hex Bolts
#6
4 Driver / Passenger Lower Mounting Bracket
#17
8 12mm ID x 37mm OD x 3mm Flat Washers
#7
2 10mm Offset Double Bolt Plates (
for front
)
#18
4 12mm Lock Washers
#8
2 10mm Double Bolt Plates (
for rear
)
#19
4 12mm Hex Nuts
#9
8 8mm x 25mm Hex Bolts
#20
8 M6-1.0mm x 20mm T-Bolts
#10
16 8mm x 16mm OD x 1.6mm Flat Washers
#21
8 6mm x 22mm OD x 2mm Flat Washers
#11
8 8mm Lock Washers
#22
8 M6 Nylon Lock Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2.
From under the driver side front of the vehicle, remove the oval grommet located on the inside
of the rocker panel,
(Figure 1)
. Insert (1) Offset Double Bolt Plate, (with threaded studs toward
the top), into the factory oval hole,
(Figure 2)
.
3.
Locate the driver side front Upper Mounting Bracket. Hold the Double Bolt Plate from one side
while you position and attach the Mounting Bracket to the opposite side. Secure the Bolt Plate
with one 10mm Flat Washer, 10mm Lock Washer and 10mm Hex Nut. Proceed to install the
rest of the hardware to secure the Mounting Bracket to the Double Bolt Plate.
(Figure 3a)
. Do
not tighten hardware at this time.
4.
Align the Mounting Bracket with holes in the pinch weld. Attach the Mounting Bracket to the
pinch weld using the included (2) 8mm x 25mm Hex Bolts, (4) 8mm Flat Washers, (2) 8mm
Lock Washers and (2) 8mm Hex Nuts.
NOTE:
Insert Bolt with Flat Washer from the outside-in.
Do not tighten hardware at this time.
5.
Select a driver front lower bracket, attach the bracket to the driver front upper bracket with
(1)12mmx35mm Hex bolt,.(2)12mm flat washers,(1)12mm lock washer and (1)12mm Hex
Nut
(Figure 3b)
.
DFM
Driver / Passenger Lower
Mounting Bracket
PRM
PFM
DRM
