CAUTION
y
The AI300 is designed to operate at the following voltages; 100, 120, 220, 230V.
The chart below provides the necessary information for the line voltage if needed.
Note: this work must be accomplished by a qualified technician only.
y
The AI300 ‘Mains’ power switch is located on the rear panel. The ‘STANDBY’ switch is located on
the front panel. During a normal daily operation use only the ‘STANDBY’ switch leaving the Mains
switch in the ‘On’ position. The amount of current draw in the standby mode is very small while the
internal circuitry is maintained at an optimal operating temperature. It is, however, recommended to
turn the Mains switch ‘Off’ or unplug the AC power lead when you plan to leave the house for a
prolonged period of time.
y
It is important to maintain proper ventilation around the AI300. Do not put other devices over the
AI300. Improper heat dissipation from and around the AI300 could cause overheating related
problems.
y
Do not open the chassis without prior authorization from the manufacturer or from a certified Stello
agent. Do not open the chassis unless you are qualified to do so. Unauthorized repair or tempering
of any type will void the manufacturer’s warranty.
VIEW FROM INSIDE
230V 220V 120V 100V
100V 120V 220V 230V
Yellow Yellow None
None
None None White
White
Blue Brown Blue Brown
Yellow Yellow Grey Grey
None None White
Red
Grey Grey None
None
Brown Blue Brown
Blue
White Red Red Red
Stello AI300
2
