33
en
7
RCTT Remote control (accessory)
The RCTT Remote control enables rapid heat-up activation via the button with-
out having to access the controller menu. It is connected to the controller with a
3-wire cable (see page 6).
If the button of the RCTT is pressed, rapid heat-up will be activated on the con-
troller. If rapid heat-up is already active, it will be deactivated.
If rapid heat-up is active on the controller, the LED of the RCTT will be perma-
nently red.
If rapid heat-up is not possible, because the temperature at sensor S3 has exceeded
the switch-off temperature BH F, the LED of the RCTT will briefly flash 3 times.
In the case of a sensor fault, the LED of the RCTT will be flashing continuously.
The RCTT Remote control has to be connected to the controller according to the
installation instructions mentioned in the RCTT Remote control manual.
