User's Manual
5.
CONFIGURING THE SECOND MTA-64
5.1.
Changing the MTA-64's address via jumper
The second MTA-64 needs to be jumpered internally to address "2". The jumper is
located on the internal PCB. To access it:
1. Remove the four screws (two upper screws on each side).
2. Remove the top cover.
3. Locate the jumper on the top and change it to position "2":
5.2.
Pinswap cable
The AES50 port has a different pinout and requires a pin swap Cat5 cable between
the MVR-64 and the MTA-64. (Note: this is the same cable which is required to use
the MADI-TP port as AES50).
10
