1
2
3
4
5
6
7
8
9 10
SCREWS
SUN SHIELD
SD PCB
LENS FAN
FRONT CASE
IR PCB
SENSOR PCB
PCB PLATE
POWER PCB
MIDDLE CASE
WATERPROOF RUBBER
REAR CASE
The 2.0-Megapixel IP Bullet Camera Indoor/outdoor (PoE)
Description of The Device
The PCB board:
The component parts ( the internal view ).
1. Plug
Inlet:
An AC 24V inlet that connects to an external power supply.
2. ETHERNET 10/100 Connector:
This is a standard RJ-45 connector for 10/100
Mbps Ethernet networks. PoE (Power over Ethernet) function: Provides power to
the device via the same cable as used for the network connection.
3. Plug
Inlet:
A DC 12V inlet that connects to an external power supply.
4. GPIO:
This is a 6-PIN connector including the
Digital output/input, DC output
and
GROUND
items
for connecting with external devices.
5. VIDEO OUT Connector:
The connector provides the unit’s composite video
signals to a monitor. (This connector adjusts and improves the images.)
6. AUDIO
IN:
The connector is used to connect the audio output from other devices
to the camera.
7. USB
port:
The user can
use a USB device cable to connect the IP camera to the
USB port on the PC.
8. AUDIO
OUT:
Provides the camera’s audio signal to a speaker or stereo.
9. SD/ SDHC CARD slot:
This is used for updating system software and archiving /
accessing critical images.
10. RESET:
Recover to factory default.
Dismantle the bullet IP camera to see its different parts. The picture here shows you
the internal component items making up the product.
Camera with bracket ( the external view ).
The picture here shows the camera's exterior, with the bracket screwed in and fixed
to it. The bracket enables you to easily mount the camera on a wall, turned at the
angle you want.
NOTE: Use the 2 screws to screw the sun shield (above) into the 2 extreme holes indicated in the
bullet camera (below) to get an unobstructed viewing angle.
Please don’t use the middle hole in the camera, as that will block the view.
1
RMN0100560
