INSTALLATION
7
CPD-3230 Customer Pole Display
3.1.2 Assembling
Insert the RJ45 end of the dual interface cable through the base
and the pipe then into the panel and connect to the RJ45 slot. You
can extend the pole to the desired height by attaching the
extension pole for different heights:
Low 173 (mm), Mid 260 (mm), High 394 (mm) and Highest
482 (mm).
NOTE: Attach the joint of the extension pole or stand base
to the Display Panel until it is properly locked.
3.1.3 Rotation
This product allows a 270 degree rotation in either horizontal direction.
ATTENTION
(1) Violently rotating the Display Panel may cause damages of
the Display Panel.
(2) Secure the Display Panel properly after attaching the
extension pole to a desired height.
3.1.4 Angling
This product allows 0~36 degree tilt angle adjustment. The Display Panel can be easily
tilted to the desired position by using a hinge design.
How to Adjust
(1) Locate the hinge section on the backside of Display Panel.
(2) Pull the tab downward and tilt the panel up or down to the desired position.
