Appliance Desk Super Combo 5500, Руководство пользователя

Страница: 14 / 26

Ring plate
Guide plate
Latch plate
1. Unscrew the adapter ring plate and the 4 adapter retaining screws.
2. Remove the guide plate if the tap is too large to fit the adapter.
3. Push the adapter onto the end of the tap so that the rubber seal forms
a watertight connection. Tighten the adapter ring plate and
the 4 screws.
4. Pull the connector latch plate down, push the inlet hose onto the adapter,
and release the connector latch plate. Make sure the adapter locks into place.
CONNECTING TO THE MACHINE
Make sure that there are no kinks in the hose and that they are not crushed.
After connecting inlet hose to water tap, turn on the water taps
substances
(dirt, sand or sawdust) in the water lines. Let water drain into a bucket
and check the water temperature.
After completing connection, if water leaks from the hose, repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square
or too big, remove the spacing ring before inserting the faucet into the adaptor.
to flush out foreign
11
24" - 40"
1.6"
Height difference between the installation location of
the washing machine and the drainage point:
Minimum 24" to Maximum 40"
Attach water drain hose to U-Connector.
Hook the U-Connector over the side or stand pipe (Fig 7.)
When the water is being drained, check that the water flow
out of the hose is adequate.
white