APPASAMY ASSOCIATES KMS 6, Руководство пользователя

Страница: 11 / 24

Lens cleaning Method.
•
Fold a piece of lens tissue four or five times to give a narrow triangular shape with a
finely pointed end.
•
Moisten the pointed end of the lens tissue with a small amount of cleaner, keeping
fingers away from the solvent to avoid contamination by oils.
•
Do not use excessive solvent such that the tissue is saturated.
•
Place the tissue against the objective front lens, so wiping and rotating the lens in
one corkscrew motion from the centre of the lens to the outside edge to avoid going
back and forth over the same area.
•
In this way the lens can be cleaned up to the edge of the cell. Further pressure will
cause the tissue to spread sufficiently to clean the whole surface. Remove any
obstinate marks by repeating the process. A new and clean piece of tissue should
be used each time.
Caution:
•
Avoid cleaning lens with abrasive or lint cloths.
•
Never
dry
wipe a lens as this may cause scratching. Begin by blowing off dust or
loose material with pressurized optical duster or bellows ball.
•
Flooding or placing solvents
directly
on the lens is discouraged.
•
Careful fogging of the lens with breath can assist in removing water-soluble residue
although caution should be exhibited in regard to excluding saliva.
•
Keep lens upright allowing tissue to touch base surface so solvent does not run into
cements or other substances holding the lens in place.
•
Disinfection instructions:
Clean the chinrest and Head stoppers with
Clean cloth after examine every patient.
11
UNPACKING & INSTALLATION