ENSTROM 480B RFM SUPPLEMENT
2-1
Report No. 28-AC-067
Mar 16/18
CHAPTER 2. NORMAL PROCEDURES
2-1. General
1. The Vision 1000 does not require flight crew interface
during aircraft operation.
NOTE
On start-up, the LED indicator will illuminate
blue for approximately 20 seconds and then
illuminate green for approximately 35
seconds. If a fault was detected, the LED
indicator will then illuminate yellow or red
depending on the fault condition (refer to
Table 7-1). If no fault was detected, the LED
indicator will remain steady green.
NOTE
If the SD card is not installed or is not
formatted correctly, the LED indicator will
illuminate yellow.
NOTE
If GPS lock is not received, the LED indicator
will illuminate yellow until the GPS signal is
valid. If there is no other error, the Vision
1000 will be recording imaging, audio, and
inertial flight data; however, the flight data
will not include GPS information (speed,
altitude, or vertical speed) until the GPS
signal is locked and the LED status is green.
2. Refer the basic RFM.
This electronic document is not linked to a subscription for revision control or distribution. Refer to the Optional Equipment
Supplement Publications Status link under the Technical Support Page of the Enstrom Helicopter website for the current revision
level of this Rotorcraft Flight Manual Supplement.
UNCONTROLLED COPY WHEN DOWNLOADED OR PRINTED
