BATTERY REPLACEMENT
The meter is powered by a single 9V battery. Refer to
Figure 2 and use the following procedure to replace the
battery:
1. Turn the meter off. Remove the thermocouple
connector.
2. Remove the holster.
3. Position the meter face down. Remove the screw from
the battery cover.
4. Remove the battery cover.
5. Lift the battery from case top, and carefully disconnect
the battery from battery connector leads.
6. Install a new battery.
7. Replace the battery cover. Reinstall the screw and
replace the holster.
BATTERY REPLACEMENT(Figure 2)
HOW TO USE THE TILT STAND AND HOLSTER
Swing the stand out for easier
meter reading.
Hang on a nail at
the workbench.
51/52
EN
Screw
Battery cover
9V Battery
Battery connector
6
