1. ACCESS THE JUMPERS & DIP SWITCHES
Open the access door by sliding it to the right. See Fig 1.
You can now see the jumper and dip switches. See Fig 2.
The Hive receiver will automatically detect volage between 12-24 V, either AC or DC.
TECHNICAL SPECIFICATIONS
3. SET THE DIP SWITCHES
Set the dip switches to the desired settings to match your transmitters SW1 controls Relay
1 and SW2 controls Relay 2. Refer to Fig 2.
2. SET THE JUMPERS
Determine the operating frequency you will use on your installation. The Hive receiver can
operate at either 300 MHz or 310 MHz. At 300 MHz the Hive receiver is compatible with all
MultiCode® transmitters with 10 dip switches operating at 300 MHz. At 310 MHz the Hive
receiver is compatible with all Linear® transmitters with 8 dip switches and Stanley®
transmitters with 10 dip switches operating at 310 MHz. See Fig 2.
A. For 300 MHz with 10 dip switches, jumpers S1 and S2 must be in place.
B. For 310 MHz with 8 dip switches, jumpers S1 and S2 must be removed.
C. For Stanley® 310 MHz with 10 dip switches, jumpber S1 must be removed and jumper S2
must be in place.
Output Load
MAX:
15A/125AC
Input Load:
12-24VAC/DC Auto Detecting
Power Supply Consumption:
Relay
Active:
70mA
Relay Not Active:
32mA
Max Applicable Power:
25VDC
Operating Temperature:
-40°F to 158°F
www.ApolloGateOpeners.com | (800) 878-7829 | [email protected]
