10
11
Choosing a Lamp
Your Daybreak is designed to control a connected lamp to provide a precise sunrise simulation, waking
you up naturally. For proper operation of your Daybreak, you need to supply a compatible lamp.
•
Use an incandescent or line-voltage halogen lamp only, up to 200W.
•
DO NOT connect fluorescent lamps, compact fluorescent bulbs, low-voltage halogen lamps, or any
lamp with a transformer or ballast. Doing so will void your Daybreak warranty and may damage your
Daybreak and the lamp.
•
Touch-activated lamps are not compatible with the Daybreak and will not operate properly when
connected.
•
3-way lamps can be connected to the Daybreak, but you should verify that the lamp remains switched
on to the highest intensity setting to ensure proper operation with the Daybreak.
Choosing a Light Bulb for Your Lamp
•
For best results, use a 100W incandescent bulb in a lamp that will light up the entire room. If you
find that you awaken too early, you can try a lower wattage bulb.
•
Special blue-enhanced light bulbs are ideal for sunrise simulation. These bulbs have neodymium added
to the glass to enhance the color. They are more expensive, but generally last longer than standard
incandescent bulbs. However, if you don’t have a neodymium bulb, a standard one will work fine.
Setting Up Y
our Daybr
eak
Setting Y
our Daybr
eak
Positioning Your Daybreak and Connecting Your Lamp
NOTE: Your lamp must plug directly into the Daybreak. Do not plug extension cords or power strips
into the Daybreak lamp socket.
1
Place your Daybreak indoors on a flat, sturdy surface away from water.
2
For best results, position your Daybreak so that you can reach the buttons and see the display at eye
level while lying down in bed.
3
Connect the AC power cord to the Daybreak and then plug the cord into a wall power outlet.
4
Plug your lamp into the socket on the back of the Daybreak.
5
Switch on your lamp. Then, press the
LAMP
button on the Daybreak to confirm that your lamp
is switched on properly. By pressing
LAMP
repeatedly, you should be able to cycle through three
intensity settings and the off position. If your lamp does not turn on, disconnect the lamp from the
Daybreak and plug it in directly to a power outlet to determine if it is functioning properly.
