background image

APD0671 A160301

© 2016 Apollo Fire

 Copyright © 2016 l 

3

Specifi cations

Input Power

120VAC 50/60Hz 12W

Backup Power

3-Volt CR2032 Battery or Equivalent

Backup Battery Life

>8 years

Operating Temperature

32°F to 122°F (0°C to 50°C)

Operating Humidity

5–95% RH non-condensing

Compatibility

ADT Lynx and ADT Vista

Wireless Signal Range

350ft (110m)

Supervisory Interval

70 minutes

Certifi cation

FCC/IC and ETL

FCC Notice

This device complies with Part 15 of the FCC’s Rules. Opera� on is subject to the following two condi� ons: 

1 This device may not cause harmful interference, and 2 This device must accept any interference received, 

including interference that may cause undesired opera� on. This equipment has been tested and found to 

comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 

designed to provide reasonable protec� on against harmful interference in a residen� al installa� on. 

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in 

accordance with the instruc� ons, may cause harmful interference to radio communica� ons. However, there is 

no guarantee that interference will not occur in a par� cular installa� on. If this equipment does cause harmful 

interference to radio or television recep� on, which can be determined by turning the equipment off  and on, 

the user is encouraged to try to correct the interference by one or more of the following measures: 

 

Reorient or relocate the receiving antenna. 

 

Increase the separation between the equipment and receiver. 

 

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

 

Consult the dealer or an experienced radio/TV technician for help. To satisfy FCC/IC RF exposure safety 

requirements, a separation distance of 20 cm or more should be maintained between this device and 

person’s body (excluding extremities: hands, wrists, feet, and ankles).

NOTE: Any changes or modi ca� ons not expressly approved by the party responsible for compliance could 

void the user’s authority to operate this equipment.

Industry Canada (IC) Compliance

This device complies with Industry Canada license-exempt RSS standard(s). Opera� on is subject to the 

following two condi� ons: (1) this device may not cause interference, and (2) this device must accept any 

interference, including interference that may cause undesired opera� on of the device. 

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de 

licence. L’exploita� on est autorisée aux deux condi� ons suivantes: 

1 l’appareil ne doit pas produire de brouillage, et 2 l’u� lisateur de l’appareil doit accepter tout brouillage 

radioélectrique subi, même si le brouillage est suscep� ble d’en comprome� re le fonc� onnement.

This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est 

conforme à la norme NMB-003 du Canada. 

Apollo

25 Corporate Drive

Auburn Hills, MI 48326 USA
TEL: +1-248-332-3900

FAX: +1-248-332-8807

www.apollo- re.com

 

 
 

 

 

 
 

 
 

 

 

 

 
 

 

 

 

 
 

 

 

 

 

 

 

 

10011636 X1

Содержание 51000-300

Страница 1: ...n trouver le circuit électrique principal qui alimente le système câblé de détec on de fumée interconnecté et l éteindre ou couper l alimenta on de ce circuit Un risque d électrocu on est présent si ce circuit électrique n est pas temporairement coupé pendant l installa on WARNING Remember to turn on or reconnect power to the primary electrical circuit thatpowerstheinterconnectedhardwiredsmokealar...

Страница 2: ... to slide the ba ery tray out of the device Remove the ba ery from the tray and replace with a new CR2032A ba ery Slide the ba ery tray back into the unit making sure that the tray is fully inserted into the unit NOTE Use Panasonic CR2032A ba eries or equivalent Use of another ba ery may damageornega velyaffecttheopera onofthedevice End of Life TheWirelessSmokeAlarmInterconnectBasedoesnothaveanEnd ...

Страница 3: ...e or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help To satisfy FCC IC RF exposure safety requirements a separation distance of 20 cm or more sh...

Страница 4: ...APD0671 A160301 2016 Apollo Fire 25 Corporate Drive Auburn Hills Michigan 48326 1 248 332 3900 FAX 1 248 332 8807 www apollo fire com SalesUSA apollo fire com ...

Отзывы: