44
Lubrication (calliper brakes)
Lubricate the brake lever and the brake calliper
pivot at least every three months with 2-3 drops
of light oil. This will help to limit wear and tear and
ensure smooth operation. At least every six months
remove cables from their casings and grease
along their entire length. Prior to fitting
any new cable, always apply grease.
Adjustment – Sidepull Callipers
To make minor brake adjustments use the barrel
cable adjuster, usually found at the upper cable
arm. Use the following outline as a guide.
1. Squeeze the brake pads against the rim
and loosen the lock nut.
2. Set the adjuster so there is approximately
1.5mm - 2mm clearance between the brake
pad and the rim.
3. Re-fasten the lock nut.
If the clearance between the brake pad and the
rim cannot be set to 2mm or less using the above
process, the cable length may need to be altered.
To do this:
1. Screw the barrel adjuster in completely.
2. Press the pads against the rim.
3. Un-fasten the cable anchor bolt and use pliers
to pull the cable through.
4. Re-fasten the cable anchor bolt.
5. Test the brake lever by applying full force, and
use the barrel adjuster to make any necessary
minor alterations.
Note: A screwdriver can be used on some brakes
to set the clearance on both sides of the rim.
Note: The leading edge of the brake pads should
make first contact with the rim when adjustment
is complete. Special curved washers are fitted
to some brakes to allow this, but on base models
a little force needs to be applied to the pad
and its mounting.
APOM0312
Apollo Bicycle Company Pty. Ltd. ABN: 60 001 914 469
