From the main menu select Data.
Connect MC-100 to a PC via USB cable or select Access to view data points on screen. Erase to delete data files.
Data
Connect to PC
Connect the included USB cable from the MC-100 to a PC (note that any USB cable may be used that has a
standard A plug to Mini-B plug). The built-in uSD memory of the MC-100 acts as a flash drive so a storage device
window will likely pop up once the connection is made. Select Open folder to view files using Windows Explorer. If
the window does not appear, go to My Computer and select the MC-100 drive. Locate the appropriate data files
(saved as a .txt file) and copy to the computer’s hard drive. Select Eject before unplugging the USB cable. Do not
turn off the PC until the USB cable has been disconnected.
Data
Access: View Data On Screen
Each data point of each data file may be viewed on screen. Select View and use the up and down arrows to select
the appropriate data file from the list. Once highlighted, select View to enter the file. Use the up and down arrows
to sequentially traverse through each data point.
Selecting Output provides the option of sending data over RS-232 communications with the use of a custom serial
cable. *NOTE: Transferring data files over a USB connection is highly recommended. If USB connection is not
available please contact Apogee Instruments technical support for more information on transferring files over RS-
232. Select Back to return to the main menu.
Data
Erase: Delete Data Files
To delete a data file from the MC-100 memory, use the up and down arrows to highlight the appropriate file.
Select Erase to delete (note there will be no additional check to verify that highlighted file should be deleted).
SYSTEM
Data Management
Connect a USB cable to
link to a PC.
Access
Back
Erase
USB Link Active!
Eject!
Data Management
View
Back
Output
1 Files
[MCDATA01]
Found
[ ]
[ ]
Cancel
Erase
Jan 1
00:00:00
Run
Data
System
