Cleaning
Birds are drawn to bird baths as a place to drink and bathe, so it's important
to keep your bird bath clean. Weekly cleaning with a brush or clean rag,
along with a bleach and water solution, will help prevent bacteria and
parasites that my harm backyard birds. During hot summer weather, check
daily to ensure that the water level is ample.
To clean your KozyBird™ Spa, simply rotate the basin counterclockwise 60˚
to release it from the mounting bracket or Pedestal, lift and tip the water out.
Reattach the basin to the bracket or Pedestal, and wipe the polymer surface
with a soft cloth. The non-stick surface should easily come clean.
CAUTION:
WARNING:
DISCONNECT THE POWER CORD FROM THE 120-VOLT
OUTLET BEFORE CLEANING AND REFILLING.
✓
NOTE!
For stubborn scale removal, mix 8 oz. of undiluted white vinegar
and 3/4 gal. of fresh water, pour into basin, let soak for 20 minutes and scrub
with a soft bristle brush until clean. Pour the liquid out and flush the basin
thoroughly with clean water before refllfing. Clean as needed.
✓
NOTE!
To disinfect your birdbath, mix 2 tablespoons of bleach and 1
cup of water, pour into basin and scrub with a soft bristle brush until clean.
Pour the liquid out and flush the basin thoroughly with clean water before
refilling. Clean once or twice a week depending on weather conditions.
✓
NOTE!
Although the KozyBird™ Spa is made from high quality material
containing additives that reduce the effects of ultraviolet (UV) exposure, the
color may changes slightly over time due to prolonged exposure to (UV)-rays
Miller Manufacturing, Glencoe, MN 55336 USA • www.miller-mfg.com
299489
Pedastal Mounting
General Information
• Construction: Single-piece fiberglass-reinforced polyester resin
• Dimensions: 17-1/2" diameter x 1-1/2'' depth
• Weight (without water): 5 lbs
• Weight (with water): 11-1/2 1bs- 13-1/2 lbs
• Capacity: Approx. 1 gal. water (3/4 gal. recommended fill)
• Voltage: 120 VAC 50/60Hz (nominal)
Wattage: 150 Watts (nominal)
• Built in thermostat that turns the unit off when the outdoor
temperature is above freezing
• Made in the U.S.A.
• U.S. Pat. No. 6,263, 158; other patents pending
• Safety: CSA certification
Double Insulated
Warranty
3 years material and workmanship
CAUTION:
THE KOZYBIRD™ PEDESTAL IS
DESIGNED FOR USE EXCLUSIVELY
WITH THE KOZYBIRD™ SPA. DO NOT
ATTEMPT TO INSTALL ANOTHER
BIRDBATH ON THE KOZYBIRD™
PEDESTAL
✓
NOTE!
Assemble your KozyBird™ Pedestal at the
desired location. (see Location Tip on
reverse side).
1. Measure the distance from the outdoor
120-volt AC outlet and the desired
location. Add on 3 feet to account for the
pedestal to determine the length of
power cord needed.
CAUTION:
WARNING:
USE OF AN OUTDOOR-RATED,
MOISTURE AND WATER RESISTANT
(TYPE SJTW OR EQUIVALENT), TWO·
CONDUCTOR POWER CORD IS
RECOMMENDED
2. Thread the socket end of the power cord
through the bottom of the Pedestal until
there is approximately 12" of slack
emerging from the top. Position the
power cord in the slot located in the
Pedestal's base.
✓
NOTE!
For exceptional stability, put
the split grommet on the power cord at the
base of the Pedestal. Slide the grommet
into the opening at the base until is snaps
into place. With the opening covered, you
may now fill the Pedestal with sand or
gravel.*
* We recommend filling the Pedestal
approximately halfway.
CAUTION:
WARNING:
DO NOT USE WATER TO FILL THE
PEDESTAL.
3. Plug the cord into the socket.
CAUTION:
WARNING:
DO NOT YET PLUG THE EXTENSION
CORD INTO A 120-VOLT AC OUTLET.
4. Coil any excess slack cord into the
Pedestal.
5. Secure the KozyBird™ Spa to the Pedestal
by rotating it 60˚ clockwise.
CAUTION:
DO NOT OVERTIGHTEN AS DAMAGE
TO THE PRODUCT MAY OCCUR. HAND
TIGHTEN ONLY
6. Fill the basin with approximately 3/4
gallon of tap water.
7. Plug the power cord into a 120-volt AC
outlet.
