385mm
Vertical distance from the floor
to the centre of the lowest
horizontal batten (with
adjustable glide wound in).
800mm
Vertical distance from
centre to centre of batten
Pod
Install Guide
Step 2: Mounting timber wall battens
Cut three 66x18mm timber battens to the required length for your Pod display (34mm shorter
than the overall display width).
Starting from the highest floor point identified in Step 1, mount your wall battens level, as
shown in the below diagram. Mount the lowest batten first, ensuring each end is 17mm from
the marked outsides of your display (Step 1). Repeat this with the upper two battens, following
the vertical spacing guide below.
800mm
Vertical distance from
centre to centre of batten
17mm
Ensure batten is mounted 17mm in from
the marked outsides of your display.
For further advice on installing your
UniSlot™ display, call
1800 111 488
or email
Page 2
