Apex Digital RH-1610, Руководство пользователя

Страница: 10 / 62

8
The printer heads have been installed before shipment, but it may need to
adjust the installation position of the head properly during calibration, or when
do machine maintenance, the nozzle may need to be disassembled and assembled.
Therefore, the installation process of the printer head is introduced here.
Pay attention to the following points when installing printer head:
1. When install the head, be careful the pin of the cable can not be lifted,
do not touch the liquid, avoid the misalignment of the connecting skew pin or
the liquid leading to the adjacent pin to cause permanent damage to the head;
2. When the head is connected to the ink tube and the exhaust tube, be careful
to distinguish the position of the ink tube and the exhaust tube;
3. Prevent the nozzle surface from being exposed to water or antifreeze and
other liquids causing the nozzle to block;
4. When the nozzle is installed on the ink cart, be careful to distinguish the direction
of the conductive pin, after confirm the correct operation, then you can fill the inks
.
(1)Schematic diagram of printer head installation sequence
Exhaust pipe
Picture 1
Picture 1. The ink tubes are connected: 2 exhaust nozzle valves with one-way
valve and 2 ink tubes with filter.
Picture 2. Take the printer head out of the box and put it on non-woven fabric.
Picture 3. Observe that the head has a positioning post, insert the exhaust
pipe into the right end of the positioning post, and insert the ink tube
into the opposite direction.
Picture 4. Schematic diagram of the printer head install with ink tube.
registration mast
3.
Installation and Operation
3.2 Printer head installation
Picture 2
Picture 3
Picture 4
Ink tube
Printer head