9
A
P
E
X
D
I
G
I
T
A
L
H
T
1
0
0
Remote Control
Continued
1
2
3
Open the cover.
OPERATING WITH THE REMOTE CONTROL
Operating HT-100 with the remote control.
1
The remote control must point at the remote sensor, in order for the
HT-100 to function correctly.
Distance: Maximum of 7 m from the front of the remote sensor.
Angle:
Approximately 30˚ from each direction.
*Please do not place the remote sensor towards any light source such as direct
sunlight or illumination. The HT-100 will malfunction, if you do so.
Insert batteries (AAA size).
Make sure to match the + and - on
the batteries to the marks inside the
battery compartment.
Close the cover.
NOTICE (BATTERIES)
PREPARING THE REMOTE CONTROL
To operate the HT-100, you must first place the batteries in the remote control.
FOLLOW INSTRUCTIONS BELOW BECAUSE INCORRECT USE OF BATTERIES MIGHT CAUSE THEM TO LEAK OR CORRODE
.
• Do not place the batteries in the wrong direction.
• It is dangerous to charge/heat/open or short-circuit the batteries.
• Do not leave dead batteries or mix old/new batteries in the remote control.
• When not using the remote control for a long duration of time, remove the batteries.
• When difficulties occur, with the remote control, or if the operating range becomes reduced, then replace the batteries.
• If leakage from the battery occurs, wipe the battery liquid from the battery compartment, then replace the batteries.
NOTICE (REMOTE CONTROL)
• The remote control should be aimed directly towards the remote sensor of the HT-100.
30˚ 30˚
