Apex Digital dBQ-zero, Руководство пользователя, Страница: 9 / 20

9
Before you get started
About this manual
Carefully read all instructions and warnings before operating
this appliance. Keep this manual in a safe place so that it can
be referred to when required.
Latest manual revision can be downloaded from:
http://www.apex-audio.be/manufacturing/support/downloads/
Inspection and unpacking
This appliance has been carefully packed in the factory and the
packaging was designed to withstand rough handling. Should
the unit appear to have been damaged in transit, do not discard
any of the packing material and notify the carrier immediately
as they would be responsible.
Save all the packing materials for future use if you ever need to
ship the unit again.
Please check the list below against the contents of the
packaging. If any items are missing or damaged, contact the
Apex dealer or distributor where you purchased the unit.
•
dBQ-zero unit
•
IEC AC power cable with mains plug
•
This manual
Operating environment
This appliance is designed to operate in moderate climates at
a temperature between 5 and 40°C (41 - 104°F) with relative
humidity no more than 60 %.
Should the unit be installed in an equipment rack, it is important
to ensure that the operating temperature inside the rack does
not exceed the upper limit. This could be the case where the
rack contains power amplifiers. A cooling fan may be necessary
in such installations.
Power requirements
BEFORE you connect any unit to the mains, please make
sure that your local AC supply is within the range of voltages
required by the unit.
The dBQ-zero is designed to work from an AC supply between
100 V and 240 V, at a frequency between 50 and 60Hz. No AC
voltage selector is provided as the device automatically adjusts
to the incoming AC voltage.
Precautions should be taken so that the appliance is properly
grounded at all times. This unit must be earthed.
Installation
If the unit is brought into a warm room from a cold environment,
internal condensation may occur. Wait an hour or two before
switching it on so that it can reach the ambient temperature.
Although this unit is intended for installation in a standard
19-inch rack it can nevertheless be used freestanding. If the
unit is installed in a flight-case or in an equipment rack, fix the
unit with all four screws through the front panel holes.
For normal use no extra support is needed, but in more
extreme conditions, such as on the road, we recommend the
unit is supported at the rear.
Allow at least 10 cm (4 inches) at the back, front and sides of
the unit for sufficient ventilation.