22
23
Locking Clip
1
2
3
5
Thread both vehicle lap and
shoulder belts through the
slot (as shown) and out other
side. Buckle. Pull up on
shoulder belt until all slack is
out and lap belt is tight.
Grasp both vehicle belts
together just behind the buckle
plate and unbuckle.
NOTE:
If the buckle plate ends
up behind the child restraint,
grasp the belts to the outside
of the child restraint, as close to
the buckle plate as possible.
Rebuckle belt. Lap belt
portion should now be
tight. If not, remove
locking clip and repeat all
steps.
Thread both portions of the
vehicle belt onto the locking
clip.
NOTE:
The locking clip is located on the back of the seat.
You do not need a locking clip when using this seat as a
belt-positioning booster.
Remove the locking clip when the seat belt is not being
used with a child restraint.
A locking clip will not fix all
types of seat belt problems.
Before you put your child restraint in the vehicle, buckle the
lap/shoulder belt. Pull on the lap belt portion. If it loosens or
slips, you must either use a locking clip to hold the seat belt
tight or move the child restraint to another seating location.
Position locking clip about
1 in. (2.5 cm) from vehicle
belt’s buckle plate.
4
4358-3616B Apex 6/21/06 10:40 AM Page 25
