Apex Digital 180413, Руководство по эксплуатации, Страница: 17 / 67

16
V-Belt Tension and Replacement
For the first few days of operation new belts
should be checked occasionally and adjusted for
tension as necessary until the belts are properly
“worn in.”
The v-belts on the main motor should
be checked for proper tension.
Tighten any of the v-belts as follows:
1. Disconnect sander from power source.
2. Loosen the lower hex nut on the motor base.
3. Tighten the top hex nut to lower the motor
plate until proper tension is achieved.
4. When the belt is properly tensioned, you
should be able to push in the belt
approximately 3/4” at a point midway
between the pulleys using moderate finger
pressure.
5. Re-tighten the bottom hex nut (Figure
9 ) against the bottom of the motor plate.
If installing a new v-belt, use the hex nuts to
raise the motor plate enough to remove the old
belt and mount the new one.
NOTE: When replacing v-belts on the main
motor, replace the entire set simultaneously.
Preferably a matched set is best .
Figure 10
Lock Nut for
Adjusting V-Belt