Polishing pads
Backing pads
Counter weight set
Screw M4x10
Counter weight cover
Output shaft
3x10 woodruff key
Skeleton oil seal
Screw M4x14
Front cover
6201 Bearing
Retaining ring
Spiral bevel gear
Retaining ring
698 Bearing
Screw M8
Handle head
Gear box
Screw ST5x25
Self lock assembly
Retaining ring
Bearing 6000
O-ring 29x1.9
Middle cover
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
1. NEVER start the machine before the
backing pad is installed.
2. Align the backing pad with the foam
pad's center. Otherwise, vibration may
be excessive.
3. Generally, lower speeds are
recommended for tight work areas
while higher speeds are ideal for
larger surface areas.
4. To prevent burning through paint, use
very light pressure and keep the
polisher moving constantly.
5. Use the polisher at low speeds while
polishing rough surfaces.
6. For tricky or tight areas, use
"coast-down" to polish. To do so, turn
the machine on for a few seconds to
enable it to oscillate, then turn it off
and use the residual oscillations to
polish.
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
Armature
Isolation mat
607 Bearing
Bearing sleeve
Wind guide
Screw ST4x65
Stator
Switch block
Switch lever
Spring
Switch
Motor housing
Brush shaft
Carbon brush
Screw ST3x6
Speed controller
Cord clamp
Screw ST4x14
Capacitance
Tail cover
Screw ST4x14
Cord sleeve
Cable / cord
Troubleshooting
1. If the polisher does not start, check the following:
• Is the power source active?
• Is the power cable on the the machine damaged?
• Are any screws on the switch loose?
• Is the switch or the speed controller damaged?
• Is the armature or stator damaged?
Best practice
2. If large sparks are visible from the side vents of the
machine, the carbon brushes may need to be replaced.
Kindly contact the Apex Customs customer support team
for further information on how to replace these.
3. If the machines become noticeably noisier over time, stop
using immediately and inspect if the bearings or counter
weight are damaged / misaligned.
Parts list
?