INSTALLATION
05
Turn your receiver/amplifier OFF before connecting speakers. This will avoid
damage which may result from accidental shorting of the speaker cable.
Use only speaker cable that is rated for in-wall use.
The Theatrus speakers can be rotated by 90, 180, or 270 degrees with the
rear pre installed threaded inserts. This allows the speaker to be positioned
in any fashion to fit the needs of the acoustic space. Included are four (4)
adhesive rubber bumpers which are to be placed in each corner of the
bottom of the speaker that is touching the surface in which the speaker rests
on, or if wall mounting then use two (2) rubber bumpers on the rear bottom
side of the speaker. This helps isolate the speaker from the set-top surface
or allows it to hang straight on the wall.
The driver unit for the TS15 subwoofer is centered, so it can also be rotated
to accommodate room positioning. Included in the packaging are four
adhesive rubber bumpers which are to be placed on the chosen bottom side
of the cabinet. This will help protect the finish from scratches and abrasions
on rough surfaces.
On-Wall Mounting (follow step by step on page 6)
*Note: For safety and security purposes, we recommend mounting speakers
directly into a wall stud for maximum strength.
1.Place the wall bracket level on wall and mark out mounting position
2.Attach the wall bracket to the wall using provided mounting hardware
3. Attached second speaker bracket to the rear of the speaker
4. Attach the 2 small rubber pads in each corner to the speaker is isolated
from the wall and it hangs straight for step 5.
5. Install speaker wire (see page 8) and place the speaker with bracket
attached to the rear onto the bracket on wall
6. Tighten the two parts of bracket together by using safety screws
7.Place the magnet grille on Speaker
8.your installation is complete