APCO
388 Grant Street, SE, Atlanta, Georgia USA 30312-2227 Telephone (404) 688-9000 www.apcosigns.com
IS309
APCO
388 Grant Street, SE, Atlanta, Georgia USA 30312-2227 Telephone (404) 688-9000 www.apcosigns.com
IS309
Contents
Site Considerations
General Notes
Handling
Mounting Surface Requirements
Surface Mounted (2300.3 Series)
Recessed Mounted (2300.1 & 2300.2 Series)
Semi-Recessed Mounted (2300.1 Series)
Full Recessed Mounted (2300.2 Series)
Preparing to Install
Open Door
Remove Display Components
Directory
Maps and Plans
Magnetic Bulletin Board
Changeable Letter Board
Cork
Board
Installation
Surface Mount Visuline Cabinet
(2-3/4” thick))
Fastening
Method
Installation
Surface Mount LP Cabinet
(3-1/2” thick))
Fastening
Method
Installation
Mounting to Metal Studs
Recessed Mounting
(2300.1 & 2300.2 Series)
Cavity
Requirements
Fastener
Suggestions
Semi-Recessed Mounting
(2300.1 Series)
Full Recessed Mounting
(2300.2 Series)
Continuous Angle Trim
Flat Bar Trim
No
Trim
Reassemble
Trouble Shooting Guide
Service & Maintenance Instructions
Need Technical Assistance?
Site Considerations
Mounting surface should be flat and plumb. Compliance will
dictate whether Visuline door will function properly.
General Notes
The following general information will be helpful to you, but is
not meant to cover all possible conditions and situations that
may occur.
Because of widely varying site conditions, installation
techniques must be determined on an individual basis. It should
be understood that common sense, caution and care are
factors which cannot be built into any product. These factors
must be supplied by the actual person(s) installing and
maintaining the product.
Handling
When handling large models you must
avoid racking and
twisting
. Assure that you have the appropriate number of
persons to accomplish this before removing the unit from its
shipping crate.
It is recommended that the protective wrapping on the door
remain until installation is complete. This will help prevent
unwanted damage while handling.
Many models have sharp corners as a result of 45 degree
miters. During handling, taping corners with masking tape
will avoid both damage to unit and the risk of a cut or injury.
06/28/01
Visuline
®
2300 Series
Non-Illuminated Display System
Wall Mount
Installation
06/28/01
Visuline
®
2300 Series
Non-Illuminated Display System
Wall Mount
Installation
Directory
Directory
Semi-Recessed
Mounted
(2300.1 Series)
Full Recessed
Mounted
(2300.2 Series)
Directory
Surface Mount
(2300.3 Series)