PA4060
OWNER’S MANUAL
4 X 60 WATT POWER AMPLIFIER
4 X 60 WATT POWER AMPLIFIER
SLIMLINE
SLIMLINE
SLIMLINE
SLIMLINE
• Read all documentation before operating your equipment.
Retain all documentation for future reference.
• Save the carton and packing material even if the equipment has arrived in good condition.
Should you ever need to ship the unit, use only the original factory packing.
• Do not spill water or other liquids into or on the unit.
• Make sure power outlets conform to the power requirements listed on the back of the unit.
• Do not use the unit if the electrical power cord is frayed or broken.
• Always operate the unit with the AC ground wire connected to the electrical system ground.
• Have gain controls on amplifiers turned down during power-up to prevent
speaker damage if there are high signal levels at the inputs.
• Do not connect the inputs / outputs of amplifiers or consoles to any other voltage source,
such as a battery, mains source, or power supply, regardless of whether
the amplifier or console is turned on or off.
• Power down & disconnect units from mains voltage before making connections.
• Do not use the unit near stoves, heat registers, radiators, or other heat producing devices.
• Do not block fan intake or exhaust ports. Do not operate equipment on a surface or in an
environment which may distort the normal flow of air around the unit. If the unit is used in an
extremely dusty or smoky environment, the unit should be periodically "blown free" of dust.
• Do not remove the cover. Removing the cover will expose you to potentially dangerous voltages.
• Do not drive the inputs with a signal level greater than that required to drive equipment
to full output.
• Do not run the output of any amplifier back into another input.
• Do not ground the red output terminal, never connect a red output terminal to
another red output terminal.
• In case of mal-function this device should be serviced by qualified service personnel only.
SAFETY INFORMATION
!!
C A U T I O N
TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER OR BACK
NO USER-SERVICEABLE PARTS INSIDE
SERVICING ONLY FOR QUALIFIED PERSONNEL
NOT ALLOWED
4 X 50 / 70 Watt
4 X 60 / 90 Watt
0.775 Vrms/MAX input level +14dBV
39 Kohm / ch.
15hz - 30KHz
<0.03%
(4 ohm) >200
320 VA MAX
44 X 483 X 325 MM
Net. 6.1 Kg
Power Rated / Max
2 ohm
4 ohm
8 ohm
Input Sensitivity
Input impedance
Freq. Response
Total harm. distortion
Damping factor
Power consumption
Dimensions (H x W x D):
Weight
Technical specifications
PA4060
• Due to the built-in limiter, some values may differ from the specs listed above.
Due to our continuous research and development, the product specifications may
change without prior notice at any time.