24) CD stereo input, 500mV: Here you can feed a line level signal. You have to make your choice with the
selector at the front (see 12). Stereo signals will be summed together.
25) AUX input, 500mV: Use this stereo RCA input to connect a line level source such as CD player, MD player,
BGM computer, etc…. You have to make your choice with the selector at the front (see 12). Stereo signals
will be summed together.
26) Line 4, 200mV / Mic 4 input. Use only one of these parallel wired inputs at the time! To the XLR3 balanced
input you can connect any microphone using a balanced, two wire shielded cable. (1=earth / 2 =hot /
3=cold). For using condenser microphones see 41. The Microphone 4 input is a XLR3/combo jack, which
will accept a normal XLR3 male plug or a ¼” TRS phone jack.
Line 4 is more sensitive than the other line (music) inputs, therefore ideal to connect wireless microphone
receivers.
27) Mic 2 Mic 3 XLR inputs. To the XLR balanced input you can connect any microphone using a balanced,
two wire shielded, cable (1=earth / 2 =hot / 3=cold).
28) Mic 1 XLR / DIN5 / Euro block. Use only one of these parallel wired balanced inputs at the time! See wiring
diagram at the back. These three inputs have been wired in parallel with the balanced jack input at the front.
When you use the APart MICPAT paging microphones, connected directly to the DIN5 input, the signals fed
into the line inputs are muted automatically while paging. The same kind of connection can be made using
the euro block connector. To use “vox mute” see 29.
Phantom power: use condenser microphones see 41
29) Vox mutes all. When you activate “vox mute” by turning this trimmer clockwise to the desired threshold
level, the signal of any Mic1 input has priority. When you don’t need “vox mute”, turn this trimmer fully
counter-clockwise to the “OFF” position.
30) Priority over music contact. By closing the contact of the euro block connector or contacts 4 and 5 of the
DIN5 connector, the signal of microphone 1 only has priority over the music sources (TUNER, CD and
AUX). All other microphones will remain active. The contact closure of the contacts mentioned can give
priority to the other microphone inputs as well. At the same time 24 V DC will be available at terminal 20.
This is very useful when using up to 4 microphones in supermarkets, etc…
31) Chime level. When one of the priority contacts are closed a chime can be activated by turning this trimmer
clockwise to the desired chime level. When you don’t need a chime, turn this control fully counter-clockwise
to the “OFF” position.
32) Emergency / telephone input. Here you can feed the audio source for paging emergency messages, etc..
This input, at line level, has automatic activation above 200mV and has a line transformer to avoid ground
loops (useful for telephone). Please use a balanced, shielded line cable. Connect the HOT signal to +,
the COLD to and the shield to G (when connecting the shield only at the MA200R side, you might avoid a
ground loop, which creates hum and buzz). This signal is directly fed into the main amplifier.
No microphones should be connected directly to this input without using a mic to line pre-amplifier.
33) Emergency / telephone level. With this potentiometer you can set the desired level of the line level signal
inserted into the priority signal input 32. This level will not be influenced by the “master” level.
34) FM antenna. This socket has to be used to connect your 75 ohm FM antenna. You can use the shipped in-
door “wire” antenna, but to improve the reception, we advise to install an outdoor FM antenna or to connect
the MA200R to the cable radio network.
Important notice: In case you connect to the cable radio network, we recommend a ground isolator HF
transformer in order to avoid hum (ground loops) or wire only connecting the HOT pin.
35) AM antenna socket. Here, the shipped indoor AM antenna has to be connected.
36) Airflow output. This airflow output should be kept free at all times! To give the fan a longer life time, he only
starts running when the heatsink reaches a certain temperature.
Содержание MA200R
Страница 1: ...INFO APART AUDIO COM MANUAL MA200R...
