APART concept1t, Инструкция по эксплуатации

Страница: 11 / 24

Instruction manual CONCEPT1(T)
11
9. Line D: stereo line RCA connector, a mini jack version of the line
D input is available on the front panel. Only use one of the two
input’s at the same time.
10. Pre-amp out: these RCA connectors offer a line level signal,
after the master volume, but before the limiter. For details,
please take a look at the block diagram on page 7.
11. Line out: these RCA connectors carry the line level signal after
passing the volume control and limiter circuit. This is an ideal
way to connect to active subwoofers or extra power amplifiers
12. Lo-cut right channel/zone 2: when this button is pushed, the
signal to the internal power amplifier reduces the sub bass
frequencies for driving small sized top speakers. It works ideally
in combination with subwoofers
13. Right channel/zone 2 output: use this euroblock connector to
connect your right/zone 2 speaker, minimum load impedance is
4 ohm (167 ohm for T version)
14. Lo-cut left channel/zone 1: when this button is pushed, the
signal to the internal power amplifier reduces the sub bass
frequencies for driving small sized top speakers. It works ideally
in combination with subwoofers
15. Left channel/zone 1 output: use this euroblock connector to
connect your left/zone 1 speaker, minimum load impedance is 4
ohm (167 ohms for T version)
16. IR jack: connect the optionally available IR remote receiver on
this minijack connector: Sleeve =GND, ring = data, tip = +5
VDC. Once this receiver is connected, the IR-receiver behind the
front panel is bypassed.