Revision 1.0
10/2016
Document No. D117-008
Page
1
of
2
Cell Connect
Quick Start Guide
A-CELL
REQUIRED SOFTWARE
The Cell Connect module requires Aparian Slate software to setup and configure. The
software installation can be found at
www.aparian.com/software/slate
.
MODULE INSTALLATION
The Cell Connect module requires input power of
10-28Vdc
. The wiring of the power
connector can be found in the wiring diagram below. The Cell Connect module
communicates on Ethernet. The Ethernet connector should be wired per industry
standards which can be found in the additional information section. The module also
requires an antenna which is connected using a SMA connector as shown below.
