Operation Instructions:
1.
Plug in the laminator and turn it on by placing the power switch in the on position. The power
light will illuminate when the unit is on.
2.
Allow the laminator to heat up for approximately 3 minutes. While the unit is preheating, the
green LED will be off. Once heated, the ready light will turn green and you can begin laminating
items.
3.
Place the paper or item to be laminated in a laminating pouch. Insert the pouch into the machine
with the pre-sealed end first. Be sure to align the item properly. Once inserted, the rollers will
start the laminating process.
4.
The pouch will exit from the rear. When finished, place the power switch in the off position then
unplug the power cord.
5.
The ABS button is used to stop the laminating process, release the document, and allow the item
to be removed from the front or rear of the unit.
6.
A carrier is not needed for most pouches and it is not recommended to use a carrier with this
laminator. If desired, place a piece of paper on top of the pouch.
ATTENTION:
Monitor the laminator at all times when the machine is turned on. DO NOT LEAVE UNATTENDED.
Please operate in an open, dry place away from temperature sensitive materials. Do not place anything
on or near the machine when it is in operation. After laminating please allow the unit to sit for 2
minutes so rollers can cool. Always unplug unit before servicing. To clean rollers use laminator roller
cleaner pads available at office supply stores. Please follow instructions included with cleaner pads.
The Limited Liability Warranty applies to laminator only. Apache Laminators is not responsible for
damage to any other personal property.
TROUBLESHOOTING:
If you experience issues, many times the laminator is either too hot or too cold. Ensure the laminator
heats up completely before using it and use a carrier or sheet of paper on top only when necessary.
During the preheat sequence, if the laminator produces an excess amount of smoke, turn off the
machine, unplug the unit and wait for the laminator to cool down. Next, visually inspect the rollers to
ensure that there is no foreign debris and remove any if necessary. Also, make sure that the rollers are
functioning and moving properly. If the problem persists, please contact Apache customer support
immediately.
CONTACT INFORMATION:
The Laminator comes with a 1 Year Manufacturer’s Warranty that does not require registration.
If you experience any issues please contact us at the phone number or email listed below.
Need technical assistance or have a question? Contact us by phone at 1-866-602-7742 or by email at
[email protected]. Our customers are our #1 priority and we would be glad to assist you.
Thank You, The Apache Team
www.apachelaminators.com
© 2014 Apache Laminators
Содержание AL9
Страница 1: ...AL9 AL9W Laminator Manual...
