AO-1505/AO-1505A ZigBee to AIDO Module
Operation Manual
Page 3 of 18
Version 1.0
Date:2012/2/17
APAC Opto Electronics Inc.
3 Tzu Chiang Road, Hsinchu Industrial Park
Hukow, Hsinchu Hsien, Taiwan 303
TEL: +886-3-5986799
FAX: +886-3-5986655
Website:
www.apacoe.com.tw
In addition, the module can be used in conjunction with the CC Debugger of TI Encoder.
Then, users can encode and compile programs by themselves. This makes the module a valuable
assistant for the development of ZigBee systems.
3.
Dimensions and Pin Assignments
Pin Function
Pin Function
Pin Function
1
GND
10
+VDD 3.3V
17
P10 =NET LED
2
GND
11
GND
18
P07 Analog IN #4
3
REST_N
12
P13 Reserved
19
P06 Analog IN #3
4
P22 (NC)
13
P12 0=C 1=R
20
P05 Analog IN #2
5
P21 (NC)
14
P11 ID Clear
21
P04 Analog IN #1
6
P17 Dout#4
15
P03 TX UART0
22
P01(NC)
7
P16 Dout#3
16
P02 RX UART0
23
P00(NC)
8
P15 Dout#2
24
+VDD 3.3V
9
P14 Dout#1
25
GND
P20 is reserved and not connected.
Note: 1. Connection of Pin 10~16 is required for AO-1505/AO-1505A ZigBee to DIDO
module, leave the remaining pins open(internal pull high).
2. Pin assignments are defined by the users if reprogrammed.
3. If use AT Command setting, you have to connect via
P03
and
P02
pin of UART.
4.
Function Selection and Initialization
4.1 Function Selection
4.2 Initialization
Since the AO-1505/AO-1505A ZigBee to AIDO module is produced with setting any
neither PAN ID nor NODE ID, initialization is required before operation. Execute the
following steps to initialize the device:
P12
P13
Function Description
1
1
Router
(AO-1505/AO-1505A
has to set the router device)
