AP Cumberland Feed-Link 2, Инструкция по установке и эксплуатации

Страница: 39 / 46

10. Display Unit Calibration and Setup
PNEG-2340 Feed-Link 2 39
Explanation of Configuration Menus (Continued)
EmtyBin lb: XXXXX
Use this menu only when the weight of the empty
tank needs to be adjusted while it is not empty*.
If you do not know the actual weight of the empty
bin, contact your AP/Cumberland dealer or Sales
Representative. The default value (first power up
after installation) is 0. Use the up or down buttons to
change each digit, and then press the “Enter” button
to advance to the next digit. Press the “Enter” button
on the final digit to save.
Example: 03500 for a bin that weighs 3,500 lbs.
The unit will now change back to Normal Display,
showing the total feed weight after accounting for
actual bin weight of 3,500 lbs.
(See Figure 10D.)
*At a later time, when the bin is completely empty,
an Empty Bin: can be performed to provide the
greatest system accuracy.
ID: 00000
Each display connected to a Network Master should
have a unique individual Node ID assigned to it.
Valid IDs are 0-50, with 0 being reserved for all
stand-alone units (no Network Master). Use the up
and down buttons to change each digit, and press
the “Enter” button to advance to the next digit.
Press the “Enter” button on the final digit to save.
(See Figure 10E.)
Re-Init Bin: No
This will return settings to factory default values in
the setup menus. By pushing the up and down
arrow buttons at the same time, the display unit
enters the initial configuration setup, then press
“Cal” button three (3) times and this menu item will
appear in the screen.
Push the up/down arrows to toggle between “Yes”
and “No” menu selection. Selecting “Yes” will set
the display unit back to its factory default values.
This can be used when a load cell is marked bad, it
can only be recovered by going back to factory
defaults. Additionally, if a load cell is ever replaced,
a return to factory defaults must be performed.
(See Figure 10F.)
Figure 10D Bin Weight Display Screen
Figure 10E ID Display Screen
Figure 10F Re-Initialization Display Screen
ENTER CAL
EmtyBin lb: 03500
ENTER CAL
ID: 00000
ENTER CAL
Re-Init Bin: No