14
OPERATING GUIDELINES
4. If solder gets stuck at the end of the barrel, clean
the barrel and wait a few more minutes for the
barrel to heat up.
5. Upon pressing the desoldering gun trigger (3),
hold the trigger for 1 to 2 seconds longer, as lar-
ger lumps of solder may need a longer suction
time to clear the barrel and go into the waste
solder cylinder(5).
6. To check if all the solder is melted, observe the
back-side of the solder pad, if solder pad cannot
be monitored, slowly move the desoldering nozzle
(see Fig.2) . if the components lead moves then
the solder has melted. Note: Never force the
component leads if it does not move then it
means the solder has not melted.
7.
Ensure that all the solder have been sucked up
(See Fig. 3), if some solder remains, resolder
pads and repeat the process.
Fig. 1
Fig. 2
Fig. 3
Содержание 8800
Страница 2: ...2 ...
