1.
Pull up the CPU socket lever and up to
90-degree angle.
2.
Locate Pin 1 in the socket and look for
a (golden) cut edge on the CPU upper
interface.
Match Pin 1 and cut edge.
Then insert the CPU into the socket.
3.
Press down the CPU socket lever and
finish CPU installation.
Plug in the CPU fan cable to the 3-pin
CPU FAN
connector. If you have chassis fan, you
can also plug it on
System FAN
(FAN2)
or
AUX FAN
(FAN3)
connector.
CPU Ratio
10x… 21x, 22x, 23x, 24x
CPU FSB (By BIOS table)
100~248MHz
Northwood CPU
CPU Core
Frequency
FSB
Clock
System
Bus
Ratio
Pentium 4 1.6G
1600MHz
100MHz
400MHz
16x
Pentium 4 1.6G
1600MHz
133MHz
533MHz
12x
Pentium 4 1.7G
1700MHz
133MHz
533MHz
13x
Pentium 4 1.8G
1800MHz
100MHz
400MHz
18x
Pentium 4 2.0G
2000MHz
100MHz
400MHz
20x
Pentium 4 2.2G
2200MHz
100MHz
400MHz
22x
Pentium 4 2.4G
2400MHz
100MHz
400MHz
24x
Pentium 4 2.4G
2400MHz
133MHz
533MHz
18x
Willamette CPU
CPU Core
Frequency
FSB
Clock
System
Bus
Ratio
Pentium 4 1.5G
1500MHz
100MHz
400MHz
15x
Pentium 4 1.6G
1600MHz
100MHz
400MHz
16x
Pentium 4 1.7G
1700MHz
100MHz
400MHz
17x
Pentium 4 1.8G
1800MHz
100MHz
400MHz
18x
Pentium 4 1.9G
1900MHz
100MHz
400MHz
19x
Pentium 4 2.0G
2000MHz
100MHz
400MHz
20x
5. Setting CPU Voltage & Frequency
Setting CPU Core Voltage
This motherboard supports CPU VID function. The CPU core voltage will be automatically
detected.
Setting CPU Frequency
This motherboard is CPU jumper-less design, you can set CPU frequency through the
BIOS setup, and no jumpers or switches are needed. The default setting is "table select
mode". You can adjust the FSB from "CPU Host/SDRAM/PCI Clock" for overclocking.
BIOS Setup > Frequency / Voltage Control > CPU Speed Setup
3. Installing Processor
Note:
If you do not match the CPU
socket Pin 1 and CPU cut edge well, it
may damage the CPU.
CPU socket lever
CPU Pin 1 and cut edge
Note:
Some CPU fans do not have
sensor pin so they cannot support fan
monitoring.
CPU Fan Connector
4. Installing CPU & System Fan
This socket supports FC-PGA2 package CPU, which is the latest CPU package developed
by Intel. Other forms of CPU package are impossible to be fitted in.
GND
+12V
SENSOR
FAN2 Connector
Warning:
Intel
®
845 G chipset
supports maximum
400/533MHz
(100/133MHz*4)
system bus and
66MHz AGP clock;
higher clock setting
may cause serious
system damage.
Note:
Since the
latest processor,
Northwood, would
detect the clock
ratio automatically,
you may not be
able to adjust the
clock ratio in BIOS
manually.
FAN3 Connector
(Without Hardware Monitor)
