The ATX power supply uses 20-pin connector shown below. Make sure you plug in the
right direction. We strongly recommend you to connect the 4-pin 12V ATX connector
before connecting the 20-pin ATX power connector.
12. Connecting CD / MODEM Connector
13. Installing LAN Driver (Optional)
10. Connecting ATX Power Connector
11. Support 2
nd
USB Port
This motherboard supports four USB ports. Two of them are on back panel connector,
the other two are on the left side of this motherboard. With proper cable, you can
connect them to front panel.
The
CD-IN
connector is used to connect CD Audio
cable from CDROM or DVD drive to onboard sound.
The
MODEM-CN
connector is used to connect
Mono In/ Mic Out cable from internal modem card to
onboard sound circuit.
MODEM-CN (Red)
Connector
Pin1
Pin2
Pin3
Pin4
CD-IN
Left
GND
GND
Right
MODEM-CN
Mono In GND
GND Mic Out
Pin 1
CD-IN
(Black)
NC
GND
SBD3+
SBD3-
+5V
KEY
GND
SBD2+
SBD2-
+5V
2 1
10 9
+5V
+5V
+5V
+5V
+3.3V
+3.3V
+3.3V
COM
COM
COM
COM
COM
COM
-5V
COM
-12V
PS-ON
PW-OK
+12V
5VSB
12V
GND
4
2
3 1
The South Bridge in Intel 845 (Brookdale) chipset integrates a total communication solution
including 10/100Mb Fast Ethernet for Office requirement. You can install LAN Driver under
Windows95/98, WindowsNT & Windows2000 by following steps.
Manually Adding an Adapter in Windows 95 / 98
=====================================
LOCATION OF DRIVER: \Driver\Lan\E100BNT5.SYS (NDIS 5.0)
LOCATION OF SETUP FILE: \Driver\Lan\NET82557.INF
1. From the Control Panel, double-click the “Add Hardware” icon.
2. Double-click Other Devices or Network Adapters in the list area.
3. Double-click a PCI Ethernet Controller.
4. Click the Driver tab, then click Update Driver.
5. Click Next at the Update Device Driver Wizard.
6. Select "Display a list of all the drivers..." and click Next.
7. Insert the AOpen Bonus CD and click Have Disk.
8. Enter the appropriate drive for your disk media
(for example: D:\) ,and click OK.
9. Click OK at the Select Device dialog box.
10. The Update Wizard displays the message that it has found
the driver. Click Next.
11. Click Finish and restart your computer when prompted.
