12. Connecting ATX Power Connector
10. JP11 BIOS Restore Function
11. Connecting IDE and Floppy Cables
This jumper allows you to enable or disable the BIOS restore function. The default setting
is Disable.
The system comes with a slim-type CD-ROM drive and a slim-type floppy disk drive.
Connect 40-pin, 80-wire IDE cable to IDE connector. A slim-type floppy disk drive is
connected with a special design cable. Be careful of the pin1 orientation. Wrong
orientation may cause system damage.
13. Installing DIMM Sockets
1
Disable
(default)
1
Enable
Dimm1
Dimm3
Dimm2
The ATX power supply uses 20-pin connector shown below. The connector is equipped
with a foolproof device. Make sure you plug in the right direction.
Floppy drive connector
ATA 100 IDE connector
RAID secondary channel
CD-ROM drive connector
RAID primary channel
This motherboard supports Advanced ECC memory Controller, 168-pin PC100 / PC133
SDRAM, Virtual Channel Memory (VCM), and ESDRAM up to 3GB.
+5V
+5V
COM
-5V
COM
+5V
+3.3V
+3.3V
COM
COM
COM
PS-ON
-12V
COM
+3.3V
5VSB
+5V
COM
+12V
PWR OK
