2. ECC Command Set
COMMAND
DESCRIPTION
AT%Cn Enable/Disable Data Compression
Enables or disables data compression negotiation.The modem can
only perform data decompression on an error corrected link. The parameter
value, if valid, is written to S41 bits 0 and 1.
AT%C0
Disables data decompression.Resets S46 bit 1.
AT%C1
Enables MNP 5 data compression negotiation.Resets
S46 bit 1.
AT%C2
Enables V.42 bis data compression.Sets S46 bit 1.
AT%C3
Enables both V.42 bis and MNp 5 data
compression.Sets S46 bit1.(Default)
AT\An Select Maximum MNP Block Size
The modem will operate an MNP error corrected link using a
maximum block size controlled by the parameter supplied. The parameter value,
if valid, is written to S40 bits 6 and 7.
AT\A0
64 characters.
AT\A1
128 characters.(Default.)
AT\A2
192 characters.
AT\A3
256 characters.
AT\Bn Transmit Break to Remote
In non-error correction mode, the modem will transmit a break signal
to the remote modem with a length in multiples of 100ms according to
parameter specified. If a number in excess of 9 is entered, 9 is used. The
command works in conjunction with the \K command. In error correction mode,
the modem will signal a break through the active error correction protocol,giving
no indication of the length.
AT\B1-\B9
Break length in 100 ms units.(Default=3,
Non-error correction mode only.)
2.1 MNP 10 Command Set
COMMAND
DESCRIPTION
AT)Mn Automatic Level Adjustment Controls
This command is included only for compatibility and performs no
function.
AT)M0
AT)M0 command.
AT)M1
AT)M1 command.
AT)M2
AT)M2 command.
Содержание FM56-ITU/2
Страница 8: ...3 2 PC Card Bracket Connection...