This motherboard provides keyboard / mouse wake-up function. You can use JP28 to enable or disable this
function, which could resume your system from suspend mode with keyboard or mouse installed. The factory
default setting is set to “Disable”(1-2), and you may enable this function by setting the jumper to 2-3.
1. JP14 Clear CMOS
Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
Online
User's Manual
can be found in the
Bonus Pack CD Disc
. Thanks for
the help of saving our earth.
PART NO: 49.8A210.E01
DOC. NO: AX4B533Tube-EG-E0206A
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
Tip: When should I Clear CMOS?
1. Boot fail because of overclocking…
2. Forget password…
3. Troubleshooting…
2. JP28 Keyboard/Mouse Wakeup Enable/Disable Jumper
This Motherboard x1
This Easy Installation Guide x1
User Manual x 1
40-wire IDE Cable x1
80-wire IDE Cable x1
Floppy Disk Drive Cable x1
Retention Module x1
Bonus Pack CD x1
Sovtek 6922 dual Triode tube x1
Cardas hyper copper wire x1 (User Upgrade Optional)
Tube Audio Card x1 (User Upgrade Optional)
Pin 1
Normal Operation
(default)
Clear CMOS
1
1
Enable
Disable
(Default)
Pin 1
