AOC AGON PORSCHE DESIGN PD27S, Руководство пользователя

Страница: 25 / 29

23
Troubleshoot
Problem & Question Possible solutions
Power LED is not ON
Make sure the power button is ON and the power cord is properly connected to a grounded
power outlet and to the monitor.
No images on the screen
Is the power cord connected properly?
Check the power cord connection and power supply.
Is the video cable connected correctly?
(Connected using the D-SUB cable)
Check the D-SUB cable connection.
(Connected using the HDMI cable)
Check the HDMI cable connection.
(Connected using the DP cable)
Check the DP cable connection.
*D-SUB/HDMI/DP input is not available on every model.
If the power is on, reboot the computer to see the initial screen (the login screen.)
If the initial screen (the login screen) appears, boot the computer in the applicable mode
(the safe mode for Windows 7/8/10) and then change the frequency of the video card.
(Refer to the Setting the Optimal Resolution)
If the initial screen (the login screen) does not appear, contact the Service Center or your
dealer.
Can you see “Input Not Supported” on the screen?
You can see this message when the signal from the video card exceeds the maximum
resolution and frequency that the monitor can handle properly.
Adjust the maximum resolution and frequency that the monitor can handle properly.
Make sure the AOC Monitor Drivers are installed.
Picture is fuzzy and has ghosting
shadowing problem
Adjust the Contrast and Brightness Controls.
Press hot-key (AUTO) to auto-adjust.
Make sure you are not using an extension cable or switch box. We recommend plugging the
monitor directly to the video card output connector on the back.
Picture bounces, flickers or wave
pattern appears in the picture
Move electrical devices that may cause electrical interference as far away from the monitor
as possible.
Use the maximum refresh rate your monitor is capable of at the resolution you are using.
Monitor is stuck in “Active Off-
Mode”
The computer power switch should be in the ON position.
The computer video card should be snugly fitted in its slot.
Make sure the monitor’s video cable is properly connected to the computer.
Inspect the monitor’s video cable and make sure no pin is bent.
Make sure your computer is operational by hitting the CAPS LOCK key on the keyboard while
observing the CAPS LOCK LED. The LED should either turn ON or OFF after hitting the CAPS
LOCK key.
Missing one of the primary colors
(RED, GREEN, or BLUE)
Inspect the monitor’s video cable and make sure that no pin is damaged.
Make sure the monitor’s video cable is properly connected to the computer.
Screen image is not centered or
sized properly
Adjust H-Position and V-Position or press hot-key (AUTO).
Picture has color defects (white
does not look white)
Adjust RGB color or select desired color temperature.
Horizontal or vertical disturbances
on the screen
Use Windows 7/8/10 shut-down mode to adjust CLOCK and FOCUS.
Press hot-key (AUTO) to auto-adjust.
Regulation & Service
Please refer to Regulation & Service Information which is in the CD manual or www.aoc.com
(to find the model you purchase in your country and to find Regulation & Service Information
in Support page).