AnyTone AT888, Руководство пользователя

Страница: 7 / 20

3
Ext. Power jack
DC power cable
REP
T
SP
Initial Installation
2
Regulated power supply (QRP-01)
DC power cable with fuse holder (QPL-01)
Black
Red
Regulated
power supply
(QRP-01)
REP T
SP
2
Red
Black
Use the full length of the cable without cutting off excess even if the
cable is longer than required. In particular, never remove the fuse
holders from the cable.
Reconnect any wiring removed from the negative terminal. 51
Connect the DC power cable to the transceiver's power supply 61
connector.
Press the connectors firmly together until the locking tab clicks.
In order to use this transceiver for fixed station operation, you will
need a separate 13.8V DC power supply (not included), power
supply( QRP-01) as optional accessories. Please contact local dealer
to require.
The recommended current capacity of your power supply is 12A.
Connect the DC power cable to the regulated DC power supply 11
and ensure that the polarities are correct. (Red: positive, Black:
negative).
Do not directly connect the transceiver to an AC outlet.
Use the supplied DC power cable to connect the transceiver to a
regulated power supply.
Do not substitute a cable with smaller gauge wires.
Connect the transceiver's DC power connector to the connector
21
on
the DC power cable.
Fixed Station Operation
REPLACING FUSES
If the fuse blows, determine the cause, then correct the problem. After
the problem is resolved, replace the fuse. If newly installed fuses continue
to blow, disconnect the power cable and contact your autho-rized
dealer or an authorized servi-cecenter for
assistance.
Press the connectors firmly together until the locking tab clicks .
Before connecting the DC power to the transceiver, be sure to
switch the transceiver and the DC power supply OFF.
Do not plug the DC power supply into an AC outlet until you make
all connections.
The EUT can be used on the vehicle.
Mobile Radio Mobile Radio