AnyTone AT-500M Скачать руководство пользователя страница 13

11

AT-500M 

This device complies with Part 15 of the FCC Rules. Operation is subject 
to the following two conditions: (1) this device does not cause any harmful 
interference; and (2) this radio must accept any interference that may 
cause undesired operations.

 

Note

: This equipment has been tested and found to comply with the limits for a  

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are  
designed to provide reasonable protection against harmful interference in a  
residential installation. This equipment generates, uses and can radiate radio  
frequency energy and, if not installed and used in accordance with the instructions,  
may cause harmful interference to radio communications. However, there is no  
guarantee that interference will not occur in a particular installation. If this equipment 
 does cause harmful interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is encouraged to try to  
correct the interference by one or more of the following measures: 

—  Reorient or relocate the receiving antenna. 
—  Increase the separation between the equipment and receiver. 
—  Connect the equipment into an outlet on a circuit different from that to which 

 the receiver is connected. 

—  Consult the dealer or an experienced radio/TV technician for help. 

 

Licensing Information 

  

  

 

Use our radio in USA is subject to the rules & regulations of FCC. Changes or 
modifications not expressly approved by our may void the user authority granted by 
the FCC to operate this radio and should not be made. To comply with FCC 
requirements, transmitter adjustments should be made only by or under the 
supervision of a person certified as technically qualified to perform transmitter 
maintenance and repairs in the private land mobile and fixed services as certified by 
an organization representative of the user of those services. Replacement of any 
transmitter component (crystal, semiconductor, etc) not authorized by the FCC 
equipment authorization for this radio could violate FCC rules.  

Note

: Use of this radio outside the country where it was intended to be distributed is 

subject to government regulations and may be prohibited. 

Important

: Any changes or modifications not expressly approved by the party 

responsible for compliance could void the user's authority to operate this device. Your 
radio is set up to transmit a regulated signal on an assigned frequency. It is against 
the law to alter or adjust the settings inside the radio to exceed those limitations. Any 
adjustments to your radio must be made by qualified technicians. 

 

WARNING: MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE 
SERVICE SIGNALS IS PROHIBITED UNDER FCC RULES AND FEDERAL LAW.

 

 

WARNING

Содержание AT-500M














Отзывы: