AnyTone AT-289, Инструкция по эксплуатации

Страница: 29 / 44

Professional
FM Transceiver
21
ADVANCED OPERATIONS
Frequency Reverse
Under the standby conditions, pressing the programmed key of Frequency Reverse, transceiver
emits " DU " beep and then comes into Frequency Reverse state. After that, the current channel RX
frequency will be switched to TX frequency, and the CTCSS or DCS signal which has been setup will
be also switched. Pressing this key again, the transceiver exits reverse function with " DU DU " beep.
Current Channel Power Enquiry
Under the standby conditions, pressing the programmed key of " Current Channel Power
Enquiry ", transceiver announces the current channel power state.
TX Power Switch
Under the standby conditions, pressing the programmed key of " TX Power Switch ", transceiver
emits BEEP prompt and announces the switched power.
Whisper
When this function is enabled, other party can hear a higher voice as long as you speak in a lower
voice.
Under the standby conditions, pressing the programmed key of " Whisper ", transceiver emits " DU "
beep and enables Whisper function. Pressing the same key again, the transceiver exits Whisper
function with " DU DU " beep.