3
|
ANYLOAD A1A Amplifier Product Manual (V1611)
From Load Cell to Amplifier:
+S:+Output mV Signal
-S:-Output mV Signal
+E:+Excitation
-E: -Excitation
4.
Specifications
Power Supply: 24V DC
}10%,<3W Maximum Input Voltage:30V DC
Input Signal: 0~30mV
Maximum Output Current: 40mA
Output Signal: 0~10V/4~20mA
Maximum Output Voltage: 15V
Operating Temperature: -10°C~40°C
Operating Humidity : ≤90%R.H.
5.
Calibration
The calibration of A1A consists of Zero Calibration and Span Calibration:
5.1 Zero Calibration
Step1.Remove all load from the scale platform. If the scale require hooks or
chains (tare weight), place the hooks or chains into the scale for zero
calibration.
Step2.Adjust ZERO variable resistor to an output of 0V or 4mA.
(Note: Tare weight shall not exceed 30% of full load)
5.2
Span Calibration
Step1.Place full load into the scale.
Step2. Adjust SPAN variable resistor to an output of 10V or 20mA.
(
Note:
It’s recommended to repeat adjustment in Step 2 of Section 5.2 above
three times.)
6.
Operation
6.1 Except during calibration, always keep the enclosure cover on and ensure
the seal is properly fitted when installing the cover.
6.2 Always keep the amplifier clean from dirt to avoid affecting the values of
the ZERO and SPAN variable resistors.
