Anybus Wireless Bridge II, Руководство пользователя

Страница: 13 / 40

Configuration 11 (38)
4 Configuration
4.1 General
Anybus Wireless Bridge II can be configured via the web interface or using one of the pre-
configured
Easy Config modes.
Advanced configuration can be carried out by issuing AT (modem) commands through the web
interface or over a Telnet or RAW TCP connection to port 8080.
4.2 Easy Config
1. Power on the unit and wait for the Link Quality LEDs to light up and go out again, then
immediately press and release the MODE button.
2. Press MODE repeatedly to cycle through the Easy Config modes until the desired mode is
indicated by the A-B-C-D LEDs.
3. Within 20 seconds of step 2, press and hold MODE for 2 seconds. When the button is
released the unit will restart in the selected mode.
4.2.1 Easy Config Modes
Mode Role Description LED
2
— Reset configuration to factory defaults. B
3 —
Reset IP settings to factory defaults. A B
4 Client
Wait for automatic configuration. C
5 WLAN AP Configure units in mode 4 as clients.
Restart as access point and connect clients. A C
6 Bluetooth NAP B C
7 WLAN AP
Configure units in mode 4 as clients.
Restart as access point and connect clients.
Apply PROFINET optimizations to all units.
A B C
8 Bluetooth NAP D
10
— Apply PROFINET optimizations and restart.
B D
Modes 5, 6, 7 and 8 will scan for units in mode 4. The detected units will be reconfigured as
clients, while the scanning unit will restart as an access point. The clients will then restart and
connect to the access point.
Modes 7 and 8 will additionally apply PROFINET optimization to all the units. PROFINET
messages will then have priority over TCP/IP frames.
Mode Timeout
• Modes 5, 6, 7 and 8 will time out after 120 seconds. Reapply the mode to repeat the scan.
• Mode 4 will listen for 120 seconds or until receiving a configuration.
The IP address of a client may be changed by the configuration from the access
point. Active browser sessions could therefore be lost.
Anybus ® Wireless Bridge II ™ User Manual SCM-1202-032 EN 1.6