Anvil HDR1011, Установка, эксплуатация и уход

Страница: 6 / 8

CLEANING
1. Always ensure that the unit is disconnected from the mains
power supply before cleaning
2. This hot dog roller should not be cleaned with a water jet or
immersed in water.
3. Using a moist cloth wipe each tube. Wipe the tubes from each
end to the centre. This will keep as much of the loosened par-
ticles out of the bearings as possible. Extend the cloth as far as
possible between the rollers.
4. With the rollers wiped with a moist cloth to loosen the particles,
now ,wipe clean with another cloth. Continue to wipe from the
end of the rollers to the centre. This will reduce the grease and
particles getting into the bearings and drive mechanism which
will extend the life of the unit and extend the period between
routine maintenance of the drive mechanism
4. Wipe off the unit with a dry cloth and wait at least half an hour
before re – connecting to the mains outlet.
5. Remove the drip pan and wash in hot,soapy water, then rinse
6. If stains are still present, add a light detergent to the cloth and
repeat.
WARNING
Burn Hazard .
Do not touch hot food,liquid or heating surfaces
while equipment is heating or operating
Hot surfaces and food can burn skin. Allow the hot surfaces to cool
before handling
THIS APPLIANCE SHOULD NOT BE CLEANED WITH
A WATER JET OR IMMERSED IN WATER. USE ONLY
A DAMP CLOTH OR SPONGE DIPPED IN SOAPY
WATER. DO NOT USE STEEL-WOOL WHICH WILL
MARK THE BRIGHT STAINLESS STEEL FINISH
NEVER USE ABRASIVE POWDERS OR PADS,THESE
CLEANERS MAY DAMAGE THE ROLLER FINISH.
ALSO,THE PARTICLES MAY GET INTO THE DRIVE
MECHANISM SHORTENING THE UNIT LIFE
8 3
EXPLODED DIAGRAM LEGEND
HOT DOG ROLLER
MODEL: HDR1011
Drawing
No.
01 TAPPING SCREW
02 RUBBER FOOT
03 BOTTOM PLATE
04 RIGHT SIDE PLATE
05 LEFT AND RIGHT FRAME
06 SILICONE PAD
07 HEATING ELEMENT FIXED PLATE
08 LEFT AND RIGHT ROLLER FIXED PLATE
09 BUSH FOR ROLLER
10 RIGHT INSIDE PLATE
11 GROUND WIRE SCREW
12 FUSE
13 ELECTRIC CABLE
14 RUBBER GASKET
15 OIL TRAY
16 ROLLER
17 HEATING PIPE
18 LEFT SIDE PLATE
19 FIBRE WASHERS
20 INSULATION PAD
21 CHAIN
22 WHEEL GEAR
23 MOTOR
24 GROMMET
25 BADGE
26 SWITCH
27 TEMPERATURE CONTROLLER WITH KNOB
28 INDICTOR LIGHT
29 FASCIA PANEL
MODEL:11 ROLLER HOT DOG MACHNE
MODEL CODE : HDR1011
Description