Anval SG 300, Инструкция по установке и обслуживанию

Страница: 20 / 28

SG
SERIES
P a g e | 20 20 20 20
Maintenance Maintenance Maintenance Maintenance
Anval slide gate valve has been designed to operate maintenance free and most parts should there
for last for its entire lifetime.
Maintenance & replacement work must be done by expert maintenance
technicians trained in the observance of applicable laws on health & safety
at work & the special ambient problems attendant on the installation.
Before doing any work on the unit, the operator must first switch off the
power to the equipment & ensure that it is out of service, as well as taking
all necessary precautions against it being accidentally switch on again or
its parts moving without warning.
Furthermore all additional environmental safety precautions must be taken (e.g. elimination of
residual gas or dust, etc)
•
Before doing any maintenance work,
activate all safety equipment and, if
necessary, inform persons working in
the vicinity. In particular, mark off the
area around the unit & prevent access
to any equipment which, if activated,
might be the cause of unexpected
health & safety hazards.
•
Replace worn components with
original spare parts only.
•
Check slide gate condition by undoing
both inspection hatches open slide
and inspect top for flatness and
guides on underside for wear.
The manufacturer declines all liability for injury & damage to components due the use of non-
original spare-parts & non-routine work which modifies the safety requirements without prior
authorisation of the manufacturer.
Do not dump polluting liquids, worn parts & maintenance waste into the
environment. Dispose of all such materials as stipulated by applicable
legislation.