INSTALLATION INSTRUCTIONS
Connecting the cables
Put the cable end into the round Connector, do
revolve the end of terminal toward right to make
sure the plug is locked up with connector, otherwise
the light will not charge normally.
Remarks:
Each cable end can be removed from the round
connector after fully charged, 1/2/3 lamp(s) can be
taken anywhere you need lighting. So even if a room
without power is far away, there is no problem, because
the light can be taken to anywhere but no need to connect with the solar panel or
connector.
After the lamp finish power just need connect the plug with connector once again
for new charge.
The same lamp can also be removed from the cables after full charge and you can
use as a torch light.
Installing the light
The LED light is designed to be suspended from the
ceiling.
At the precise location on the ceiling where you have
planned to suspend the led light, drill a hole 2cm in
diameter, barely large enough to allow a Bayonet Plug
to pass through.
Insert the Bayonet Plug of the cable provided, into
the port on top of the light.
Pass other bayonet plug and rest of the cable through
the hole in the ceiling you just made.
Slip the cable into the Ceiling Cap provided, through a slit on its side.
Maintain the led light at desired height.
Then fasten Ceiling Cap to the ceiling with screws, covering up the hole on the ceiling.
Connect the bayonet plug that has been passed through the ceiling, to any available
ports on the Hub4 Repeat the above steps for all lamps in the kit.
POWER TO THE PEOPLE
4
5
Since it is a battery operated product, regular usage (Charge & Discharge) is required
for longer life of batteries.
