8
P/N 1012011 Rev. C 06/18
Quarterly Cleaning
Remove Belt Wraps and Clean
Rollers
1. Turn the toaster’s power switch
to the off position. The toaster
enters a cool-down mode and
will automatically shut down
when complete.
2. Unplug the power cord once the
cool-down period is complete.
NOTICE:
Wait for the cool-down
period to complete before
unplugging the power cord.
3. Remove the bun feeder using
heat-resistant gloves.
NOTICE:
Reposition the toaster
as needed to perform these
steps.
4. Unlock the lock on the right side
panel with a flathead screw
-
driver and open the panel. Turn
the compression knobs (there
are 2) to 7.
Loose
Loose
Figure 2.
Loosening the conveyor
rollers
5. Remove tension on the Top
Belt by pushing the Top FRONT
Roller IN and UP until it locks
into position.
6. Remove tension on the Bot-
tom Belt by pushing the Bottom
FRONT Roller IN and DOWN.
7. Unlock the Top and bottom lock
levers. (See below).
Upper Frame
Belt Lock
Unlocked
Lower Frame
Belt Lock
Unlocked
Figure 3.
Conveyor locks
8. Carefully remove the two top
belts and one bottom belt.
Upper Belt Wraps
Lower Belt
Wrap
Figure 4.
Belt Wraps
9. Wipe all four rollers and back-
ing plates with a clean, damp
sanitized towel. Make sure to re-
move all debris from the rollers
and the backing plates so they
are as clean as possible.
10. Use a dry cloth towel or nylon-
bristled brush to remove all
debris from both side compart-
ments, inside of the toaster, and
underneath the rollers.
Install Belt Wraps
1.
If you are installing the existing
belt wraps, inspect the belts.
Replace belt wraps if worn or
damaged. If the belt wraps are
in good condition put them back
on the toaster.
2.
For new or existing belts, wipe
both sides of the belts with a
clean, damp sanitized towel. Al-
low to air dry.
3. Slide the belts gently over the
appropriate top and bottom
roller. Make sure the belt lines
up properly on the rollers. The
snaps on the belts should face
the inside of the roller.
4. Restore tension on the bottom
belt by pushing UP and OUT
(See Below).
5. Restore the tension on the top
belt by pushing DOWN and
OUT (See Below).
Tense
Tense
Figure 5.
Conveyor rollers under
tension
NOTICE:
Lift up on the camshaft of
the rear conveyor roller while lifting
the conveyor lock.
Upper Frame
Belt Lock
Engaged
Lower Frame
Belt Lock
Engaged
Figure 6.
Belt frame locks
6. Engage the top and bottom lock
levers as shown above. Make
sure the lock lever is properly in-
serted into the slotted grooves.
7. Close the side panel and lock
the lock using a flathead screw
-
driver on the side panel.
8. Set the Crown compression
knob to 4 and the Heel to 3.
9. Re install the top cover and bun
feeder onto the unit.
10. Plug in the power cord and turn
the unit on.
