Antunes DCH-1000, Руководство пользователя

Страница: 3 / 17

P/N 1011306 Rev. D 12/17 3
IMPORTANT SAFETY
INFORMATION
Use the following guidelines for safe opera-
tion of the unit.
y Read all instructions before
using equipment.
y For your safety, the equipment is
furnished with a properly grounded
cord connector. Do not attempt to
defeat the grounded connector.
y
Install or locate the equipment only
for its intended use as described in
this manual. Do not use corrosive
chemicals in this equipment.
y
Do not operate this equipment if
it has a damaged cord or plug, if
it is not working properly, or if it
has been damaged or dropped.
y
This equipment should be serviced
by qualified personnel only. Contact
your nearest Authorized Service
Agency for adjustment or repair.
y
Do not block or cover any
openings on the unit.
y Do not immerse cord or plug in water.
y
Keep cord away from heated surfaces.
y
Do not allow cord to hang over
edge of table or counter.
y
Turn the power off, unplug the
power cord, and allow unit to cool
down before performing any service
or maintenance on the unit.
y
The equipment should be grounded
according to local electrical codes to
prevent the possibility of electrical
shock. It requires a grounded
receptacle with separate electrical
lines, protected by fuses or circuit
breaker of the proper rating.
y
All electrical connections must be in
accordance with local electrical codes
and any other applicable codes.
y
Do not clean this appliance
with a water jet.
WARNINGS
Be advised of the following warnings when
operating and performing maintenance on
this unit.
y If the supply cord is damaged,
it must be replaced by the
manufacturer or its service agent
or a similarly qualified person
in order to avoid a hazard.
y
Do not modify the power supply
cord plug. If it does not fit the
outlet, have a proper outlet
installed by a qualified electrician.
y
Do not use an extension
cord with this appliance.
y
Electrical ground is required
on this appliance.
y
Check with a qualified electrician
if you are unsure if the appliance
is properly grounded.
y
If a chemical cleaner is used,
be sure it is safe to use on cast
aluminum. Observe all precautions
and warnings on product label.
y Inspection, testing, and
repair of electrical equipment
should only be performed by
qualified service personnel.
y
Do not use abrasive materials. The
use of these may cause damage
to the stainless steel finish.
y
Chlorides or phosphates in cleaning
agents (e.g. bleach, sanitizers,
degreasers or detergents) could cause
permanent damage to stainless steel
equipment. The damage is usually in
the form of discoloration, dulling of
metal surface finish, pits, voids, holes,
or cracks. This damage is permanent
and not covered by warranty.
The following tips are recommended
for maintenance of your stainless steel
equipment:
y
Always use soft, damp cloth for
cleaning, rinse with clear water and
wipe dry. When required, always rub
in direction of metal polish lines.
y Routine cleaning should be
done daily with soap, ammonia
detergent, and water.
y Stains and spots should be sponged
using a vinegar solution.
y Finger marks and smears should be
rubbed off using soap and water.
y Hard water spots should be
removed using a vinegar solution.